HP Remote Assistant Card - Manual (Page 55)

2 Hardware Installation and Configuration
37
Enabling Paging for Events
The window also provides checkboxes for specifying events that will initiate a page to
configured administrators. (All events are logged even if they are not enabled for
paging.)
NOTE HP Remote Assistant events can also generate alarms on an SNMP
Management console. For more information on creating and viewing alarms,
see Chapter 5.
When an event tagged for paging occurs, HP Remote Assistant will dial all numeric
pager numbers and send two codes: the three-digit number identifying the server on
which the event occurred (you can set this with the Server Identification command),
and a four-digit number identifying the event. Alphanumeric pagers display the server
name and a string describing the eliciting event. For a complete listing of event codes
used for paging, see Appendix A.
Page on NOS Hang (ASR). When enabled, HP Remote Assistant sends a notification
whenever it detects that the server NOS has hung and initiated an Automatic Server
Restart. (This option requires installation of the appropriate ASR driver software.)
Page on Temperature Warning Threshold Exceeded. When enabled, HP Remote
Assistant sends a notification when it detects a temperature above the threshold
specified as acceptable.
Page on Voltage Warning Threshold Exceeded. When enabled, HP Remote
Assistant sends a notification when it detects a voltage outside the range specified in
the configuration (or a complete power failure).
Page on Bus Utilization Warning Threshold Exceeded. When enabled, HP Remote
Assistant sends a notification when it measures a five-minute average bus utilization
above the threshold specified as acceptable in the configuration.
Page on Illegal Login Attempt. When enabled, HP Remote Assistant sends a
notification whenever it detects three successive attempts by an unauthorized user to
log into HP Remote Assistant. An “attempt” is defined as a dial-in, followed by one to
three login failures and a disconnect.
The following three features are only available on an HP NetServer LS, LH Pro, or LX
Pro with the BIOS version included on the provided HP NetServer Navigator CD-
ROM. More recent BIOS versions are also supported.
Page on System Hardware Failure. When enabled, HP Remote Assistant sends a
notification whenever it detects a hardware failure (such as an ECC multi-bit error or
fan failure).