Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1720)

Dynamic Host Configuration Protocol (DHCP) Commands
Software Reference for x310 Series Switches
64.22 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
service dhcp-server
This command enables the DHCP server on your device. The server then listens for DHCP
requests on all IP interfaces. It will not run if there are no IP interfaces configured.
The no variant of this command disables the DHCP server.
Syntax service dhcp-server
no service dhcp-server
Mode Global Configuration
Example To enable the DHCP server, use the commands:
Related Commands ip dhcp pool
show ip dhcp server summary
subnet-mask
awplus# configure terminal
awplus(config)# service dhcp-server