Ip address – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 647

Advertising

IP Addressing and Protocol Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

25.13

ip address

This command sets a static IP address on an interface. To set the primary IP address on the
interface, specify only ip address <ip-address/m>. This overwrites any configured
primary IP address. To add additional IP addresses on this interface, use the secondary
parameter. You must configure a primary address on the interface before configuring a
secondary address.

The no variant of this command removes the IP address from the interface. You cannot
remove the primary address when a secondary address is present.

Syntax

ip address <ip-addr/prefix-length> [secondary [label <label>]]

no ip address <ip-addr/prefix-length> [secondary]

no ip address

Mode

Interface Configuration for a VLAN interface or a local loopback interface.

Examples

To add the primary IP address 10.10.10.50/24 to the interface vlan3, use the
following commands:

To add the secondary IP address 10.10.11.50/24 to the same interface, use the
following commands:

Note

Use show running-config interface not show ip interface brief when you need
to view a secondary address configured on an interface. show ip interface brief
will only show the primary address not a secondary address for an interface.

Parameter

Description

<ip-addr/prefix-
length>

The IPv4 address and prefix length you are assigning to the

interface.

label

Adds a user-defined description of the secondary IP address.

<label>

A user-defined description of the secondary IP address. Valid
characters are any printable character and spaces.

awplus#

configure terminal

awplus(config)#

interface vlan3

awplus(config-if)#

ip address 10.10.10.50/24