Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 563)

Link Aggregation Introduction and Configuration
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 20.7
Commands Used lacp system-priority
channel-group
Validation
Commands
show lacp sys-id
show port etherchannel
show etherchannel
show etherchannel detail
awplus(config-if)#
exit Exit the Interface Configuration mode and
return to the Global Configuration mode.
awplus(config)#
interface port1.0.4 Enter the Interface Configuration mode to
configure port 1.0.4.
awplus(config-if)#
channel-group 1 mode active Add this interface to a channel group 1 and
enable link aggregation so that it may be
selected for aggregation by the local system.
awplus(config-if)#
interface po1 Select the dynamic aggregator logical
interface created for channel-group 1 named
po1
.
Table 20-2: Switch 2 configuration