JLG 1500SJ Service Manual - Manual (Page 127)

SECTION 3 - CHASSIS & TURNTABLE
3121262 – JLG Lift – 3-79
5. If the end cover (2) is equipped with shuttle valve
components, remove the two previously loosened
plugs (21).
BE READY TO CATCH THE SHUTTLE VALVE OR RELIEF VALVE
COMPONENTS THAT WILL FALL OUT OF THE END COVER VALVE
CAVITY WHEN THE PLUGS ARE REMOVED.
NOTE: The insert and if included the orifice plug in the end
cover (2) must not be removed as they are serviced
as an integral part of the end cover.
1. Special Bolts
2. End Cover
3. Seal Ring-Commutator
4. Seal Ring
5. Commutator Ring
6. Commutator Ring
7. Manifold
8. Rotor Set
8A. Rotor 8B. Stator or Stator Vane
8C. Vane
8D. Stator Half
9. Wear Plate
10. Drive Link
11. Not Used
12. Coupling Shaft
13. Bearing/Bushing, Inner
14. Thrust Washer 15. Thrust Bearing
16. Seal
17. Back-up Washer
18. Housing
18A. O-Ring
19. Bearing/Bushing, Outer
20. Dirt & Water Seal
21. Plug
Figure 3-48. Swing Drive Motor