JLG 1500SJ Service Manual - Manual (Page 537)

SECTION 6 - JLG CONTROL SYSTEM
3121262 – JLG Lift – 6-85
22. When the system completes this step, the next
screen will show:
23. Press ENTER. The screen should read as shown
below. The control system will jib level down and
stop the jib leveling command.
24. When the system completes the previous step, the
screen will read:
25. Hitting the escape key (ESC) will take the system
back to the initial jib lift calibration display.
NOTE: At this point the left or right arrow key may be used to
skip to any of the other jib sensor calibrations.