JLG 1500SJ Service Manual User Manual
Page 282
Advertising
SECTION 4 - BOOM & PLATFORM
4-36
– JLG Lift –
3121262
TAKE EXTRA CARE NOT TO CROSS ANY WIRE ROPES DURING
THE ASSEMBLY PROCEDURE.
1. Install the fly extend wire rope button ends into the
slots on the bottom of the fly boom section. Place
tape over the wire ends to keep them in place during
assembly.
2. Fabricate a special fixture as shown below to keep
four extend wire ropes from crossing over each
other.
3. Install the fly retract wire rope button ends into the
slots in the side of the fly boom, coil the remaining
lengths of wire rope and place them into the fly
boom, tape the slots to keep the rope from jumping
out.
Advertising