JLG 1500SJ Service Manual User Manual

Page 132

Advertising
background image

SECTION 3 - CHASSIS & TURNTABLE

3-84

– JLG Lift –

3121262

replaced. If the housing has passed this inspection
the disassembly of the Torqlink™ is completed.

NOTE: The depth or location of bearing/bushing (13) in rela-

tion to the housing wear plate surface and the depth

or location of bearing/bushing (19) in relation to the

beginning of bearing/bushing counter bore should be

measured and noted before removing the bearings/

bushings. This will facilitate the correct reassembly

of new bearings/bushings.

22. If the bearings, bushing or thrust washers must be

replaced use a suitable size bearing puller to
remove bearing/bushings (19) and (13) from hous-
ing (18) without damaging the housing. Remove
thrust washers (14) and thrust bearing (15) if they
were previously retained in the housing by bearing
(13).

Advertising