JLG 1500SJ Service Manual - Manual (Page 161)

SECTION 3 - CHASSIS & TURNTABLE
3121262 – JLG Lift – 3-113
12. Lift the turntable into place on the bearing using the
previously installed guide pins for alignment.
13. Install all of the inner race bearing bolts hand tight.
Remove the guide pins to install the last two bolts.
After all of the bolts are installed, tighten them until
snug. Disconnect the front lifting device at the front
of the turntable (leaving the rear lifting device in
place) to gain full access to all bolts and torque the
bolts according to the torquing procedures in this
section.
14. After all swing bearing bolts are torqued, the rear lift-
ing device can be disconnected.
15. Connect the hoses to the top of the swivel as tagged
during removal. Secure the hoses together with a tie
strap as shown.
16. Using an adequate lifting device, set the swing drive
in place on the turntable. Make sure the swing bear-
ing high spot is still aligned with the swing drive
gear. If necessary, swing the turntable slightly to
align the mark with the gear.