JLG X20JP - X600AJ Service Manual - Manual (Page 102)

SECTION 3 - CHASSIS & TURNTABLE
3-78 – JLG Lift – 3121623
CLEANING THE EXHAUST MESH INLET
EXHAUST SYSTEM COMPONENTS WILL NATURALLY BE HOT
AND MUST NOT BE TOUCHED WHILE THE ENGINE IS RUNNING
OR UNTIL IT HAS COOLED DOWN AFTER BEING STOPPED.
– Unscrew hex nut and remove the exhaust mesh insert.
– Remove any deposits in the mesh insert by means of a
wire brush.
– Check the exhaust mesh insert for cracks or damage
and, if necessary replace with a new one.
– Screw on hexagon nut „1“ by approx. 1 turn.
– Insert exhaust screen with hook „1“ into hole, them pull
outwards again so that the hook is retained.
– Tighten the hexagon nut fully.
2442 / 6
2441 / 12