JLG X20JP - X600AJ Service Manual - Manual (Page 276)

SECTION 6 - JLG CONTROL SYSTEM
6-60 – JLG Lift – 3121623
4 - ELECTRICAL MOTOR
1. Press button 7 "SETUP“.
2. Press button 5 “PASSWORD”.
Using the remote control buttons to enter the pass-
word "Level 2":3522.
NOTE: password above allow to choose the options shown on the
screen.
Once the correct password is accepted the display
shown “OK”.
3. Press button 9 “ESC”.
Repeat the above steps if “NO” appear on the dis-
play.
4. Press button 3 ”EXTRA”
5. Press button 1 "OPTIONAL"
6. Press button 4 “EL.MOT”.
7. Press button 1 2,2 KW for 220- 240 Volt 50HZ.
8. Press button 2 1,2 KW” for 110 Volt 60HZ.
Press 5 times button 9 Esc to escape
5 - LAMP ON OUTRIGGER
1. Press button 7 "SETUP“.
2. Press button 5 “PASSWORD”.
Using the remote control buttons to enter the pass-
word 6661.
NOTE: password above allow to choose the options shown on the
screen.
Once the correct password is accepted the display
shown “OK”.
3. Press button 9 “ESC”.
Repeat the above steps if “NO” appear on the dis-
play.
4. Press button 3 ”EXTRA”
5. Press button 1 "OPTIONAL".
6. Press button 5 “LAMPS”.
7. Press button 1 for Lamps continuously ON. Press
button 1 for lamps continuously ON with outrigger
on the ground and full work area active, while blink-
ing in restricted work area.
8. Press button 2 for Lamps Blinking. Press button 2 for
lamps blinking with outrigger on the ground while
lamps ON in restricted work area.
Press 5 times button 9 to Esc to escape