JLG X20JP - X600AJ Service Manual User Manual
Page 86
SECTION 3 - CHASSIS & TURNTABLE
3-62
– JLG Lift –
3121623
9. Wind the rope onto the reel counterclockwise and
hook the starter rope into the cutout of the starter
reel.
10. Wind the starter spring and install it to the starter reel
by aligning the outer hook to the groove of the reel.
11. Apply grease to the spring hook and boss of the
starter case. Align the spring inner hook to the case
claw on the case by turning the reel counterclock-
wise.
12. Install the ratchet spring and ratchet as shown.
Apply grease to the friction spring and inside of the
ratchet guide. Install the spring end f friction plate,
and then install the ratchet guide by aligning the "
∆
"
marks of the ratchet guide with the ratchets. Tighten
the setting screw securely.
13. Turn the reel three full turns counterclockwise to pre-
soak the starter spring.