JLG X20JP - X600AJ Service Manual - Manual (Page 176)

SECTION 4 - BOOM & PLATFORM
3121623 – JLG Lift – 4-23
4.6 PLATFORM REMOVAL/INSTALLATION
NOTE: If the platform is removed only track movement is
allowed.
1. Remove the platform/remote control box from the
mounting support.
2. Loosen and remove the aluminium caps that secure
the platform to the jib platform mounting posts.
3. Lift the platform off the mounting posts in an upward
direction. Place platform aside for later installation.
Platform Installation
1. LIft the platform and align the platform mounts with
the jib mounting posts and lower until seated.
2. Secure the platform to the jib mounting posts with
the aluminum threaded caps. Do not overtighten.
3. Re-install the platform/remote control box into the
mounting support on the platform.
1
2
3
2
Figure 4-26.