Air cleaner – JLG X20JP - X600AJ Service Manual User Manual

Page 77

Advertising
background image

SECTION 3 - CHASSIS & TURNTABLE

3121623

– JLG Lift –

3-53

Oil change:

5. Check the engine on a level surface and remove the

oil filler cap.

6. Remove the oil drain bolt and sealing washer. and

drain the oil into a suitable container.

Please dispose of used motor oil in a manner that is
compatible with the environment. We suggest you
take use oil In a sealed container to your local recy-
cling center or service station for reclamation. Do
not throw it in the trash. pour it into the ground, or
down a drain.

USED ENGINE OIL CONTAINS SUBSTANCES THAT HAVE BEEN
IDENTIFIED AS CARCINOGENIC. IF REPEATEDLY LEFT IN CON-
TACT WITH THE SKIN FOR PROLONGED PERIODS, IT MAY CAUSE
SKIN CANCER. WASH YOUR HANDS THOROUGHLY WITH SOAP
AND WATER AS SOON AS POSSIBLE AFTER CONTACT WITH
USED ENGINE OIL.

7. Tighten the oil drain bolt and a new sealing washer

to the specified torque.

TORQUE: 45 N·m (4.5 kgf·m, 33 lbf·ft)

8. Refill with the commended oil.

9. Check the oil level and, if the oil level is near or

below the lower limit mark on the oil level gauge, fill
with the recommended oil to the upper level mark.

10. Install the oil filler cap.

AIR CLEANER

Cleaning:

A dirty air cleaner will restrict air flow to the carburetor,
reducing engine performance. If the engine is operated in
dusty areas, clean the air cleaner more often than speci-
fied In the MAINTENANCE SCHEDULE.

1. Remove the air cleaner cover nut and air cleaner

cover.

2. Remove the wing nut, air cleaner elements (paper

element and foam element) and air cleaner elbow
packing, and separate them. Carefully check both
elements for hole, or tear: and replace if damaged.
Check the air cleaner claw packing for deterioration
or damage.

3. Foam element: Clean the element in warm soapy

water, rinse and allow to dry thoroughly, or clean
with a Nigh flash point solvent and allow to dry thor-
oughly. Dip the element in clear engine oil and
squeeze out all the excess oil. Excess oil will restrict

Engine oil capacity

1.10 l (1.16 US qt, 0.97 lmp qt)

Advertising
This manual is related to the following products: