10 engine removal – JLG X20JP - X600AJ Service Manual User Manual
Page 151
Advertising
SECTION 3 - CHASSIS & TURNTABLE
3121623
– JLG Lift –
3-127
3.10 ENGINE REMOVAL
1. Stabilize and turn the machine on level surface at
90° (image 1).
2. Remove the key ignition, and a tag with warning do
not start the machine.
3. Remove the cover 1. (image 1)
4. Disconnect, tag and isolate the wires from the
engine.
NOTE: On X23J-X700AJ diesel disconnect the oil pipes and cool-
ing lines, than drain the 2 circuities.
5. Unscrew the screws (13-5 image 2).
6. Remove the engine (Kg 70), remove the joint (8-9
Image 2) .
7. Remove the muffler (6 Image 2).
8. Replace the engine and tighten the screws (13-5
Image 2) respectively with the copies of tightening of
22Nm and 25Nm.
9. Connect the wires to the motor.
10. Replace guard on motor (1) and test the machine.
Advertising
This manual is related to the following products: