JLG X20JP - X600AJ Service Manual - Manual (Page 128)

SECTION 3 - CHASSIS & TURNTABLE
3-104 – JLG Lift – 3121623
PERKINS RPM CONTROL SYSTEM
Mount the proximity cod.26514900 sure that inside see
the hole on the reduction of the tooth crown, screw until
you come into abutment with the sensor, make a mark
and unscrew for a ride, then pull the nut to secure it.
Take the wire and cut proximity 350mm, thread a a sheath
L = 300 and mount connector 2-way super seel female
leads of the connector (1) red and black wire on the (2).
Take No. 1 throttle servo cod.26551500, No. 1 piston
mounting bracket Electrical cod.06551300, n° 1 articula-
tion, No. 4 vibration ø12, 5 H = 10 cod.06551400, n° 1
threaded rod accelerator cod.06471400, No. 1 stud for
accelerator cod.06471500 and n ° 2 screws 5/16 X 3/4.
25. Slightly flared the 4 threaded holes of the servo
command, cut one side of the fillets of vibration to
about 5-6MM.
26. Put a little 'of fat on the joint where she works and a
M6 nut low.
1 2
1