JLG X20JP - X600AJ Service Manual - Manual (Page 129)

SECTION 3 - CHASSIS & TURNTABLE
3121623 – JLG Lift – 3-105
27. Mount it on the servo control and tighten until bot-
tom.
28. Cut to 10mm bolt for the throttle, tighten and tighten
down with nut M6.
29. Orientate the bracket with 2 screws + washer 5/
16X3/4 flat. Removing one at a time to put the thread
lock and pull.
30. Mount the actuator and record it in line, check the
operation with the help of a battery.
31. Wires 2 on the actuator to a sheath L = 250 and a
connector with 2-way super-seel door males. The
red wire on connector (2) and black wire on connec-
tor (1).
3
2
2
1 2