JLG X20JP - X600AJ Service Manual - Manual (Page 106)

SECTION 3 - CHASSIS & TURNTABLE
3-82 – JLG Lift – 3121623
– Loosen screw „1“ with approx. 5 rotations.
– Remove oil filter from housing.
– Use an air line to blow out oil filter dirt from the inside
outwards.
PERSONS HANDLING COMPRESSED AIR MUST WEAR PROTEC-
TIVE GOGGLES.
– Check joint washer „1“whether it is damage; replace-
ment if necessary.
– Check joint washer „2“whether it is damage and cor-
rectly fitted, replace oil filter if necessary.
– Lubricate joint washer before fitting.
– Put in oil filter and press until limit stop.
– Check whether tension springs sit close to oil filter with
both ends „1“, before tightening screw.
– Check the oil level and restore to the max. level if
required.
2445 / 10