JLG X20JP - X600AJ Service Manual - Manual (Page 279)

SECTION 6 - JLG CONTROL SYSTEM
3121623 – JLG Lift – 6-63
3 - ENABLE DRIVE SWITCH (RC MOV)
This menu allows to set ON or OFF the enable drive
switch.
The enable drive switch (button 8) allow the drive function
with remote control off of the basket.
1. Press button 7 "SETUP“.
2. Press button 5 “PASSWORD”.
Using the remote control buttons to enter the pass-
word 4771.
NOTE: password above allow to choose the options shown on the
screen.
Once the correct password is accepted the display
shown “OK”.
3. Press button 9 “ESC”.
Repeat the above steps if “NO” appear on the dis-
play.
4. Press button 3 ”EXTRA”
5. Press button 1 "OPTIONAL".
6. Press button 3 "RC MOV"
7. Press button 1 ON to activate the function
8. Press button 2 OFF to deactivate the function
Press 5 times button 9 to Esc to escape
2 - SOFTWARE UPDATE (FIRMWARE)
This menu allow to flash a software on ECM 1-2, ECM 3
and the MODEM.
When on the ECM1-2 is uploaded a “new” software ver-
sion, different as of the currently installed one, on the
remote control display right-down corner it is visualized a
unique icon, as follows.
This function allow flash the software stored on the
modem to the ECM’s or on modem module.
1. Press button 7 "SETUP“.
2. Press button 5 “PASSWORD”.
Using the remote control buttons to enter the pass-
word 1883 "Level 2".
NOTE: password above allow to choose the options shown on the
screen.
Once the correct password is accepted the display
shown “OK”.
3. Press button 9 “ESC”.
Repeat the above steps if “NO” appear on the dis-
play.
4. Press button 3 ”EXTRA”
5. Press button 2 "FIRMWARE".