JLG X20JP - X600AJ Service Manual User Manual
Page 190
Advertising
SECTION 5 - HYDRAULICS
5-12
– JLG Lift –
3121623
Replace the seals on the piston. DO NOT attempt to sal-
vage cylinder seals, sealing rings or o-rings. ALWAYS use
a new, complete seal kit when rebuilding hydraulic com-
ponents. Consult the parts manual for ordering informa-
tion.
Mount the seals in the following order:
1. Seal
2. Support bearing
3. Bearing
Install the piston on to the end of the cylinder rod. Loc-
tite® 270TM
NOTE: If a white powdery residue is present on threads and parts,
it can be removed. Clean the residue away with a soft
brass wire brush prior to reassembly, and wipe clean
before reinstallation.
Refer to “Hydraulic Cylinder Torque Specifications,” for
tightening guidelines for the piston.
Advertising
This manual is related to the following products: