JLG X20JP - X600AJ Service Manual - Manual (Page 124)

SECTION 3 - CHASSIS & TURNTABLE
3-100 – JLG Lift – 3121623
INSTALLATION PROCEDURE
KEEP ALL PARTS CLEAN FROM CONTAMINANTS. CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
1. Ensure that the fuel filter base is clean and free from
damage. If necessary, replace the fuel filter base.
2. Align fuel filter base (2) with the mounting bracket.
Install bolt (1). Tighten the bolt to a torque of 25 N·m
(18 lb ft).
3. If necessary, install a new fuel filter element (6) to
fuel filter base (2). Refer to Operation and Mainte-
nance Manual, “Fuel System Filter - Replace”.
4. Connect hoses (4) and tighten hose clamps (3).
NOTE: Ensure that the hoses do not contact any other
engine components.
5. Turn the fuel supply to the ON position.
6. Remove the air from the fuel system. Refer to Opera-
tion and Maintenance Manual, “Fuel System -
Prime”.
FUEL TRANSFER PUMP - REMOVE AND INSTALL
(MECHANICAL FUEL TRANSFER PUMP)
REMOVAL PROCEDURE
DO NOT ALLOW DIRT TO ENTER THE FUEL SYSTEM. THOR-
OUGHLY CLEAN THE AREA AROUND A FUEL SYSTEM COMPO-
NENT THAT WILL BE DISCONNECTED. FIT A SUITABLE COVER
OVER DISCONNECTED FUEL SYSTEM COMPONENT.
CARE MUST BE TAKEN TO ENSURE THAT FLUIDS ARE CON-
TAINED DURING PERFORMANCE OF INSPECTION, MAINTE-
NANCE, TESTING, ADJUSTING AND REPAIR OF THE PRODUCT.
BE PREPARED TO COLLECT THE FLUID WITH SUITABLE CON-
TAINERS BEFORE OPENING ANY COMPARTMENT OR DISASSEM-
BLING ANY COMPONENT CONTAINING FLUIDS. DISPOSE OF ALL
FLUIDS ACCORDING TO LOCAL REGULATIONS AND MANDATES.
KEEP ALL PARTS CLEAN FROM CONTAMINANTS. CONTAMI-
NANTS MAY CAUSE RAPID WEAR AND SHORTENED COMPONENT
LIFE.
NOTE: Place identification marks on all hoses for installation
purposes. Plug all hoses and all the ports in the fuel trans-
fer pump. This helps prevent fluid loss, and this helps to
keep contaminants from entering the system.
1. Turn the fuel supply to the OFF position.