RKI Instruments SDM-E2 - Manual (Page 14)

9 • Description
Control Panel
The control panel is used to setup and operate the docking station in the Standalone
configuration. It is located at the front of the docking station. It includes the control
buttons, the control button LEDs, and the CHARGE status LED.
Five control buttons are located on the control panel. From left to right they are BUMP
T
, CAL
S
, EDIT ENTER, COPY, and POWER. The BUMP
T
, CAL
S
, EDIT
ENTER, and COPY control buttons are not used in the PC Controlled configuration of
the SDM-E2. The BUMP
T
LED and CAL
S
LEDs indicate the results of bump tests
and calibrations, respectively. The COPY LED does not indicate anything in the PC
Controlled configuration but will be on if the SDM-E2 was used in the Standalone
configuration and calibration and bump test records are still stored in the SDM-E2’s
memory. The CHARGE LED is located above the POWER button and functions as a
pilot LED, a system failure LED, and a charge indication LED.
The POWER button turns the SDM-E2 on and off.
Figure 8: Control Panel