RKI Instruments SDM-E2 User Manual
Page 47
Connecting Instruments to the PC Controller Program • 42
LED will begin to flash amber. If the batteries are fully charged, the CHARGE
LED will become solid green again after about 5 minutes. Typically a bump test
or calibration will be initiated before this happens. See “Charging an
Instrument in an SDM-E2” on page 103 for a complete description of charging
the EAGLE 2.
WARNING:
Do not plug the charger cable into a battery pack that contains alkaline
batteries. Do not attempt to charge alkaline batteries.
7.
When a connection has been established between the SDM Docking Station
PC Controller Program and all of the SDM-E2s, the main program window will
appear as shown below.
Figure 28: SDM-E2 Connection
8.
Connect the gas out to EAGLE 2 line of each SDM-E2 to the inlet of each
EAGLE 2.