RKI Instruments SDM-E2 - Manual (Page 41)

Setting Up the PC Controller Program • 36
3. The Parameter Tab of the Configuration Window will be displayed.
Figure 23: Config Window Parameter Tab
4. Click the box next to Initialize Display Order in the SDM portion of the
Parameter tab.
5. Click OK.
6. The program will ask if you want to save the changes. Click Yes.
7. A window will appear informing you that you need to turn off all SDM-E2s and
restart the program. Click OK.
8. Click the Exit button in the upper right corner of the main program window to
exit the program.
9. Turn off all of the SDM-E2s if they are on.
10. Open the SDM Docking Station PC Controller program again.
11. Turn on your SDM-E2s in the order that you wish for them to appear on the
main program window. Typically the order in which the docking stations appear
on the screen corresponds to their left to right arrangement on the tabletop.
12. Your SDM-E2 docking stations should all appear on the screen in numerical
order. The program will remember each SDM-E2’s number. If fewer than all of
the docking stations are turned on, the stations will still appear in numerical