RKI Instruments SDM-E2 User Manual
Page 46
41 • Connecting Instruments to the PC Controller Program
WARNING:
Inserting the EAGLE 2 improperly may damage the exhaust bellow at the
back of the SDM-E2.
Figure 27: Inserting the EAGLE 2
4.
Turn on each SDM-E2 by pressing and holding the SDM-E2’s POWER button.
When the control panel LEDs turn on, release the POWER button.
5.
The BUMP
T
and CAL
S
LEDs will turn off and the COPY LED will be
steadily on or off. It will be on if the SDM-E2 was used in Standalone
Configuration and calibration and bump test records are still stored in the
SDM-E2’s memory (see the SDM-E2 Docking Station Standalone
Configuration Manual for more information). The CHARGE LED will be
blinking green if the SDM-E2 is operating properly or solid red if there is a
system failure.
6.
If any of the EAGLE 2s are equipped with NiMH batteries and you wish to
charge the batteries, connect the charging cable at the front of the SDM-E2(s)
to the charging jack on the back of the applicable instrument(s). The CHARGE
C
a
li
b
ra
ti
o
n
S
ta
tio
n
CO
P
Y
EA
G
L
E 2
O
F
F
CH
A
R
G
E
1 S
E
C
O
N
3 S
E
C
O
F
F
CA
L
ED
IT
EN
T
E
R
PO
W
E
R
SD
M-
E2
BU
M
P
A
IR
Y
E
S
R
A
N
G
E
S
H
I
F
T
P
O
W
E
R
E
N
T
E
R
R
E
S
E
T
D
IS
P
L
A
Y
A
D
J
U
S
T
N
O