Rockwell Automation MV SMC Flex Motor Controller (for Series K or later) - Manual (Page 113)

Rockwell Automation Publication 1560E-UM051F-EN-P - June 2013 103
Communication Chapter 8
The control panel provides the operator interface to the controller.
Start
The green start button, when pressed, will begin motor operation.
(Proper setup of the HIM port is required.)
Stop
The red stop button, when pressed, will halt motor operation
and/or reset a fault.
Jog
The jog button is active only when a control option is present.
Pressing the jog button will initiate the option maneuver (for
example: Pump Stop).
All other controls available with the various human interface modules are
non-functional with the SMC Flex controller.
ATTENTION: The Bulletin 20-HIM interface module's stop push button is not
intended to be used as an emergency stop. Refer to the applicable standards for
emergency stop requirements.
ATTENTION: The external HIM has a similar programming operation to the
built-in programmer, but note that differences do exist.
Sel Jog