Rockwell Automation MV SMC Flex Motor Controller (for Series K or later) - Manual (Page 118)

108 Rockwell Automation Publication 1560E-UM051F-EN-P - June 2013
Chapter 8 Communication
SMC Flex Bit Identification
Table 15 - Logic Status Word
Bit # Status Description
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
X Enabled 1 – Control Power Applied
0 – No Control Power
X Running 1 – Power Applied to Motor
0 – Power not Applied to Motor
X Phasing 1 – ABC Phasing
0 – CBA Phasing
X Phasing Active 1 – 3-phase is valid
0 – No valid 3-phase is detected
X Starting (Accel) 1 – Performing a Start Maneuver
0 – Not performing a Start Maneuver
X Stopping (Decel) 1 – Performing a Stop Maneuver
0 – Not performing a Stop Maneuver
X Alarm 1 – Alarm Present
0 – No Alarm Present
X Fault 1 – Fault Condition Exists
0 – No Fault Condition
X At Speed 1 – Full Voltage Applied
0 – Not Full Voltage Applied
X Start/ Isolation 1 – Start/Isolation Contactor Enabled
0 – Start/Isolation Contactor Disabled
X Bypass 1 – Bypass Contactor Enabled
0 – Bypass Contactor Disabled
X Ready 1 – Ready
0 – Not Ready
X X Option 1 Input 1 – Input Active
0 – Input Inactive
X X Option 2 Input 1 – Input Active
0 – Input Inactive
— — Bits 12 to 15 – Not Used