Rockwell Automation MV SMC Flex Motor Controller (for Series K or later) - Manual (Page 88)

78 Rockwell Automation Publication 1560E-UM051F-EN-P - June 2013
Chapter 4 Programming
Parameter Modification All parameters are modified using the same method. The basic steps to
performing parameter modification are described below.
Notes:
1. Parameter values modified while the motor is operating are not valid until
the next start sequence begins.
2. If the password is set, parameters cannot be adjusted without logging in.
3. Use the Sel key to highlight a single digit.
Description Action Display
(2)
(2) The display will indicate that the second line is now active by highlighting the first character. If the LCD display does not provide a
highlighted cursor, then the controller is in the Display mode.
— —
1. Press the ESC key to go from the status
display to the Main menu.
—
2. Scroll with the Up/Down keys until the
Preferences option is highlighted.
3. Press the Enter key to access the
Parameter menu.
4. Scroll with the Up/Down keys until the
option you want to use (Monitoring,
Motor Protection, etc.) is highlighted. For
this example, Set Up will be used.
5. Press Enter to select the Set Up group.
—
6. Scroll to Basic Set Up and press Enter.
(1)
(1) The SMC Option advises the user if any control option (i.e., Pump Control) is resident. This parameter is factory set and cannot be
modified by the user.
7. Scroll to the Starting Mode parameter by
using the Up/Down keys, and press Enter.
8. Press Enter to select the option. Scroll to
the option of your choice by using the Up/
Down keys. For this example, we will
choose Current Limit.
9. Press the Enter key to accept the new
setting.
—
10.Scroll to the next parameter by using the
Down key. Continue the process until all
desired settings are entered.
Sel Esc