Rockwell Automation MV SMC Flex Motor Controller (for Series K or later) - Manual (Page 203)

Rockwell Automation Publication 1560E-UM051F-EN-P - June 2013 193
ArcShield Plenum Installation Instructions Appendix E
STEP 6 – Mounting
Extension/Elbow to Plenum
“Line-up” As referred to in STEP 4 – Closing the Front of the Plenum Sections on
page 191 , the last Plenum at the exhaust side of the line-up has the front duct
section removed. This allows access to fastener holes in order to mount the
Extension/Elbow components (see
Figure 99 ).
Figure 99 - Optional Extension/Elbow with Vertical Extension (Right side exit)
After the Extension/Elbow assembly is attached through the fastener holes on
the inside flange of the Plenum, the front duct section can be replaced and
fastened through the holes on the outside flanges.
Last Plenum in Line-up
remains open for installation
of Extension Assembly