Rockwell Automation MV SMC Flex Motor Controller (for Series K or later) - Manual (Page 121)

Rockwell Automation Publication 1560E-UM051F-EN-P - June 2013 111
Communication Chapter 8
Parameters 88 to 103 are used to configure the DataLinks. For additional
information regarding DataLinks, refer to the user manual for the
communication interface being used.
Updating Firmware The latest version of firmware and instructions for the SMC Flex can be obtained
from www.ab.com.
TIP Node addressing of the DPI communication card can be programmed via
software or a hand-held DPI HIM. The on-board HIM cannot be used to address
the communication card.
TIP The MV SMC Flex must use firmware release 3.006 or later. This User Manual
pertains to units with firmware release 4.xxx (or later).