Rockwell Automation MV SMC Flex Motor Controller (for Series K or later) - Manual (Page 173)

Rockwell Automation Publication 1560E-UM051F-EN-P - June 2013 163
Parameter Information Appendix B
Group Parameter Description Parameter
Number
Units Min / Max Default
Settings
User
Settings
Linear List Fault 1 124 0…255
Fault 2 125 0…255
Fault 3 126 0…255
Fault 4 127 0…255
Fault 5 128 0…255
Basic Set Up Option 1 Input 132 Disable
Stop Option
Fault
Fault NC
Network Stop
Option
Stop Input 133 Coast
Stop Option Coast
Tuning and Special Parameters
(Visible with 6.001 and later firmware.)
(Visible and writable only with Password
1196 on 5.00n and earlier firmware.)
Pump Pedestal 34 % 0…50 0 (2)
Braking Time 36 Sec 0…999 0 (3)
Load Type 37 Standard
High Inertia
High Friction
Ramp 89 Standard (2)
High Eff. Brake 38 % 0…99 0 (3)
OL Shunt Time 48 Sec 0…999 0
OL Trip Enable 49 Disable
Enable Enable
Line Fault 84 Disable
Disable F1
Disable F41
Enable Enable
Emergency Run 85 Disable
Enable Disable
Current Loss 86 Disable
Enable Enable
Timed Start 112 Disable
Enable Disable See Param.
#114
I Shutoff Level 113 % 0…37 0 Do not
change
UTS Level 114 % 0…100 75
V Shutoff Level 117 % 0…100 25
OL Reset Level 118 % 0…99 75
Ambient Temp. 119 0…60 50 Do not
change
Notch Position 120 % 40.0…100.0 87.5 Do not
change
Notch Maximum 121 50…70 70 Do not
change
Start Delay 122 Sec 0…30 0
Bypass Delay 123 Sec 0…15 0
Start Time E 129 Sec 0…999 0
Start Time E2 130 Sec 0…999 0
Stop Time E 131 Sec 0…999 0
Elapsed Time 2 134 Hours 0…3000 (1)
(1) Read-only parameter
(2) Pump modules only
(3) Brake modules only