Rockwell Automation MV SMC Flex Motor Controller (for Series K or later) - Manual (Page 53)

Rockwell Automation Publication 1560E-UM051F-EN-P - June 2013 43
Installation Chapter 2
To make power connections for a two-high cabinet, refer to Figure 28 to
Figure 30 , and Publication 1500-UM055_-EN-P (Chapter 2).
To make power connections for a one-high FVNR cabinet and a 1560E unit,
proceed as follows:
• Make line connections within the one-high cabinet
• Make load connections at the 1512 CT terminals
Bulletin 1560E
Refer to Figure 31 to Figure 33 to make power connection for a 1560E unit
(depending on the rating of the unit).
• Make line connections to the line connection terminals
• Make load connections to the current transformer terminals
ATTENTION: Bulletin 1562E units provided with an arc resistant enclosure must
be installed in accordance with instructions in Publication 1500-UM055_-EN-P.
Failure to do so may result in damage to equipment or personal injury.
TIP The CT assembly can be oriented to allow either top or bottom load cable exit.