Rockwell Automation 6008-SV2R VMEbus remote I/O Scanner - Manual (Page 121)

Chapter
Operating in SVĆSuperset Mode
6
6Ć40
CONTINUOUS BT WRITE transfers a block of data from the scanner to
the specified I/O module at regular intervals. When one block-transfer
write completes, the scanner queues another one. The cycle continues until
you disable the continuous block transfer.
The scanner must be in Program mode to execute this command. If the
scanner isn’t in Program mode, the scanner returns error code 13 (Program
mode required) to the confirmation status byte. Once this command is
running, you can halt a continuous block-transfer by switching the scanner
to Program mode.
CONTINUOUS BT WRITE
command byte 07
description