Rockwell Automation 6008-SV2R VMEbus remote I/O Scanner User Manual
Page 26
Chapter
Installing the Scanner
2
2Ć7
Insert the scanner in one slot in a 6U (full-height) VMEbus chassis.
ATTENTION: Make sure that your VME system is powered
off. The scanner is not designed to be inserted or removed from
a live system.
ATTENTION: Avoid touching the circuit board
and connectors. You might damage the board, or electrostatic
discharge might damage the board.
Use the VME chassis card guides to slide the scanner into the chassis. Use
firm pressure on the top and bottom handles of the scanner to make its
P1 connector fit firmly into the connector on the backplane. Tighten the
screws on the top and bottom of the front panel to prevent the scanner
from loosening.
The scanner operates on 5V dc @ 2.3A (typical), 2.5A (maximum).
Inserting the Scanner
Determining PowerĆSupply
Requirements