Rockwell Automation 6008-SV2R VMEbus remote I/O Scanner - Manual (Page 128)

Chapter
Starting the Scanner
7
7Ć2
SET MODE
command
(PROGRAM)
SET MODE
command
(RUN)
possible scanner states
POST state
successful self test
scanner set for SVĆcompatible
or SVĆsuperset mode
SLEEP state
PROGRAM state
VME master writes any
value to scanner ID area
wake up the scanner
SET MODE
command
(TEST)
TEST state
RUN state
SET MODE
command
(RUN)
SET MODE
command
(TEST)
SET MODE
command
(PROGRAM)
power cycle
SYSRESET
DEAD state
self test failed
SYSFAIL state
RESET command
SYSFAIL
SYSFAIL
SYSFAIL
FAULTED state
FLT LED on scanner lights
remote I/O communication shuts down
adapters go to their failsafe modes
scanner waits for power cycle, VME SYSRESET
command, or scanner RESET command
FLT LED on scanner blinks
must cycle power