Rockwell Automation GV3000/SE 230VAC 1-20 HP GP & Vector Drive Ver. 6.04 Software Start-Up and Ref. User Manual

Page 38

Advertising

1-24

GV3000/SE 230 VAC Drive, Software Reference Version 6.04

This example shows the Hz value
corresponding to the value set in parameter
P.004, Maximum Speed. Your actual
reading may be different.

VALUE READ:

This example shows the output amps at
Maximum Speed (P.004). Your actual
reading may be different.

VALUE READ:

Step 8.4 Press the ENTER key to move to the AMPS display.

Step 8.5 Press the ENTER key to move to the Hz display.

AUTO

MAN

Forward
Reverse

PROGRAM

RUN
JOG

STOP

RESET

START

ENTER

SPEED
VOLTS
AMPS
Hz
Kw
TORQUE
Password

RUNNING
REMOTE
JOG
AUTO
FORWARD
REVERSE
PROGRAM

Step 8.6 Press the STOP/RESET key. The driven motor should stop as

programmed in P.025, Stop Type.

End of V/Hz Start-Up Procedure

This is the end of the basic V/Hz start-up procedure. When the start-up values are
final, Appendix B can be used to record final settings.

To configure remaining parameters according to the specific application, refer to
Chapter 4, Programming Reference. If you have purchased the Control and
Configuration Software (CS3000), save your configuration to a personal computer.
Refer to the CS3000 software instruction manual (D2-3348) for this procedure.

Recall that the Control Source parameter (P.000) was set to LOCL in this start-up
procedure. If you need to operate the drive from a different control source, you will
need to change the setting in parameter P.000.