Rockwell Automation GV3000/SE 230VAC 1-20 HP GP & Vector Drive Ver. 6.04 Software Start-Up and Ref. User Manual

Page 55

Advertising

2-17

Starting Up the Drive for Vector Regulation

Step 6.8 Press the ENTER key to display the default setting of U.001.

ATTENTION: Do not use a 4096 PPR encoder with 2-pole motor.
Overspeed and motor damage can result. Failure to observe this
precaution could result in bodily injury.

This displays the default setting for Encoder
PPR, 1024 PPR.

AUTO

MAN

Forward
Reverse

PROGRAM

RUN
JOG

STOP

RESET

START

ENTER

SPEED
VOLTS
AMPS
Hz
Kw
TORQUE
Password

RUNNING
REMOTE
JOG
AUTO
FORWARD
REVERSE
PROGRAM

Step 6.9 Press the

key to increase the PPR, or the

key to decrease the PPR.

Select one of the four PPR values if an
encoder is used. Select SE if an encoder is
not used. See the description of U.001 in
Chapter 4 for more information.

VALUE ENTERED:

Step 6.10 Press the ENTER key to save the changed value.

After pressing ENTER, the same parameter
is displayed. You can now move to the next
parameter.