Rockwell Automation GV3000/SE 230VAC 1-20 HP GP & Vector Drive Ver. 6.04 Software Start-Up and Ref. - Manual (Page 77)

3-1 Using the Keypad/Display To Program, Monitor, and Control the Drive
Figure 3.1 – Keypad/Display
C
HAPTER
3
Using the Keypad/Display To Program,
Monitor, and Control the Drive
The front-panel keypad/display is used to program, monitor, and control the drive. It
operates in two modes, monitor mode and program mode. The functions available
at the keypad depend on what mode the keypad/display is in and what is selected
as the drive control source.
In monitor mode (the default mode), you can monitor specific drive outputs as well
as enter the speed or frequency reference for the drive.
In program mode, you can view and adjust drive parameter values, and examine the
error log.
In addition to the functions listed above, if the control source is local (the REMOTE
LED is off), the keypad is also used to select run or jog, select motor direction, and
start the drive.
Regardless of the control source selection, the keypad/display can be used to stop
the drive, reset drive faults, and switch between a manual speed reference or the
selected control source auto reference.
Important: The STOP/RESET key can be disabled by parameter P.055. Refer to
the P.055 parameter description for more information.
The following sections describe monitor mode and program mode in more detail.
The keypad, display, and LEDs are described later in this chapter.
ENTER
STOP
RESET
START
RUN
JOG
AUTO
MAN
Forward
Reverse
PROGRAM
SPEED
VOLTS
AMPS
Hz
Kw
TORQUE
Password RUNNING
REMOTE
JOG
AUTO
FORWARD
REVERSE
PROGRAM
Start Key Stop/Reset
Key
Password LED
Monitor Mode
LEDs
Display
Drive Status LEDs
Keypad