Rockwell Automation GV3000/SE 230VAC 1-20 HP GP & Vector Drive Ver. 6.04 Software Start-Up and Ref. - Manual (Page 59)

2-21
Starting Up the Drive for Vector Regulation
Step 6.20 Press the ENTER key to display the default setting of U.004.
This displays the Motor Nameplate Amps
setting. The default depends on the HP
rating of the Power Module. The display
shown here is only an example.
Step 6.21 Press the £ key to increase the motor nameplate amps or the ¥ key
to decrease the motor nameplate amps.
The minimum and maximum allowed
adjustment range for this value depends on
the Power Module HP rating.
VALUE ENTERED:
Step 6.22 Press the ENTER key to save the changed value.
After pressing ENTER, the same parameter
is displayed. You can now move to the next
parameter.
AUTO
MAN
Forward
Reverse
PROGRAM
RUN
JOG
STOP
RESET
START
ENTER
SPEED
VOLTS
AMPS
Hz
Kw
TORQUE
Password RUNNING
REMOTE
JOG
AUTO
FORWARD
REVERSE
PROGRAM
AUTO
MAN
Forward
Reverse
PROGRAM
RUN
JOG
STOP
RESET
START
ENTER
SPEED
VOLTS
AMPS
Hz
Kw
TORQUE
Password RUNNING
REMOTE
JOG
AUTO
FORWARD
REVERSE
PROGRAM