Dell PowerVault MD3420 - Manual (Page 138)

Parameters
Parameter Description
repositoryRAIDLevel The RAID level for the replication repository virtual
disk. Valid values are 0, 1, 5, or 6.
repositoryPhysicalDisks The physical disks for the replication repository
virtual disk. For high-capacity expansion
enclosures, specify the enclosure ID value, the
drawer ID value, and the slot ID value for each
physical disk that you assign to the replication
repository virtual disk. For low-capacity expansion
enclosures, specify the enclosure ID value and the
slot ID value for each physical disk that you assign
to the replication repository virtual disk. Enclosure
ID values are 0 to 99. Drawer ID values are 0 to 4.
Slot ID values are 0 to 31. Enclose the enclosure ID
values, the drawer ID values, and the slot ID values
in parentheses.
repositoryDiskGroupUserLabel The name that you want to give the new disk
group in which the replication repository virtual
disk is located. Enclose the disk group name in
double quotation marks (" ").
repositoryDiskGroup The name of the replication repository disk group
where the replication repository virtual disk is
located.
To determine the names of the disk groups in your
storage array, run the show storageArray
profile command.
freeCapacityArea The index number of the free space in an existing
disk group that you want to use to create the
replication repository virtual disk. Free capacity is
defined as the free capacity between existing
virtual disks in a disk group. For example, a disk
group might have the following areas: virtual disk 1,
free capacity, virtual disk 2, free capacity, virtual
disk 3, free capacity. To use the free capacity
following virtual disk 2, you would specify:
freeCapacityArea=2
Run the show diskGroup command to determine
if a free capacity area exists.
repositoryPhysicalDiskCount The number of unassigned physical disks that you
want to use for the replication repository virtual
disk.
enclosureLossProtect The setting to enforce enclosure loss protection
when you create the replication repository virtual
disk. To enforce enclosure loss protection, set this
parameter to TRUE. The default value is FALSE.
drawerLossProtect The setting to enforce drawer loss protection
when you create the replication repository virtual
disk. To enforce drawer loss protection, set this
parameter to TRUE. The default value is FALSE.
138