Dell PowerVault MD3420 - Manual (Page 24)

Parameter Definition
-h Use with the -a and -x parameters to specify the
host name that is running the SNMP agent to
which the storage array is connected.
-I Use to specify the type of information to be
included in the e-mail alert notifications. The
following are valid information arguments:
• eventOnly— Only event information is
included in the e-mail.
• profile— Event and array profile information
is included in the e-mail.
• supportBundle— Event and support bundle
information is included in the e-mail.
NOTE: You can enter only one information
argument each time you execute the
command. If you want all of the information,
you must run the command three times.
-i Use with the -d parameter to display the IP address
of the known storage arrays.
-m Use to specify the host name or IP address of the
e-mail server from which to send e-mail alert
notifications.
-n Use to specify the name of the storage array on
which to run the script commands. This name is
optional when you use host
‑name-or-IP-
address; however, if you are using the in-band
method for managing the storage array, you must
use the -n parameter if more than one storage
array is connected to the host at the specified
address. The storage array name is required when
host
‑name-or-IP-address is not used;
however, the name of the storage array configured
for use in the MD Storage Manager GUI (that is,
listed in the configuration file) must not be a
duplicate name of any other configured storage
array.
-o Use with the -c or -f parameter to specify a file
name for all output text that is a result of running
the script commands.
-p Use to specify the password for the storage array
on which to run commands. A password is not
necessary under the following conditions:
• A password has not been set on the storage
array.
24