Dell PowerVault MD3420 - Manual (Page 378)

Start Storage Array Blink
Description
This command identifies a storage array by turning on the indicator LED for the storage array. Use the
stop storageArray blink command to turn off the indicator LED for the storage array.
Syntax
start storageArray blink
Parameters
None.
Start Storage Array Configuration Database Diagnostic
Description
This command runs a consistency check against a configuration database.
Syntax
start storageArray configDbDiagnostic
[sourceLocation=(disk | onboard)]
[diagnosticType = (fileSystem | mirror | contentCheck)]
[raidControllerModule[(0 | 1)]]
Parameters
Parameter Description
sourceLocation This parameter specifies the location of the
database.
• disk indicates that data comes directly from
the database on the physical disk.
• onboard indicates that data comes from the
RPA memory location
The default location is disk.
diagnosticType The level of diagnostic testing that you want to run
on the database. You can run one of these levels of
testing:
fileSystem This option checks the
structural integrity of the
database.
mirror
• When the
sourceLocation
378