Dell PowerVault MD3420 - Manual (Page 261)

Parameter
Parameter Description
physicalDisk Identifies the enclosure and slot where, the
physical disk resides. Enclosure ID values are 0 to
99. Slot ID values are 0 to 31. You must put
brackets ([ ]) around the enclosure ID value and the
slot ID value.
Revive Snapshot Group
Description
This command forces the specified snapshot group to the Optimal state. If the snapshot group is not in a
Failed state, the firmware displays an error message and does not run this command.
Syntax
revive snapGroup [snapGroupName]
Parameter
Parameter Description
snapGroup The alphanumeric identifier (including - and _) of
the snapshot group that you want to set to the
Optimal state. Enclose the snapshot group
identifier in square brackets ([ ]).
Revive Snapshot Virtual Disk
Description
This command forces a specified snapshot virtual disk to the Optimal state. The snapshot virtual disk can
be:
• A standalone snapshot virtual disk
• A snapshot virtual disk that is a member of a consistency group
If the snapshot virtual disk is not in a Failed state, the firmware displays an error message and does not
run this command.
NOTE: You cannot use this command for a snapshot virtual disk that is used in online virtual disk
copy.
Syntax
revive snapVirtualDisk [snapVirtualDiskName]
261