Dell PowerVault MD3420 - Manual (Page 302)

Parameter Description
autoDeleteLimit The maximum number of snapshot images that
you want to automatically delete if you have
selected to purge the snapshot images for a
repository full policy. Use integer values. The
default value is 32.
rollBackPriority Use this parameter to determine whether system
resources should be allocated to the rollback
operation at the expense of system performance.
Valid values are highest, high, medium, low, or
lowest. A value of high indicates that the rollback
operation is prioritized over all other host I/O. A
value of lowest indicates that the rollback
operation should be performed with minimal
impact to host I/O.
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.
When you use this command, you can specify one or more of the parameters. You do not, however,
need to use all of the parameters.
Set Snapshot Group Media Scan
Description
This command runs a media scan on a snapshot group.
Syntax
set snapGroup ["snapGroupName"]
mediaScanEnabled=(TRUE | FALSE)
consistencyCheckEnabled=(TRUE | FALSE)
Parameters
Parameter Description
snapGroup The alphanumeric identifier (including - and _) of
the snapshot group on which you want to run a
media scan. Enclose the snapshot group name in
double quotation marks (" ") inside of square
brackets ([ ]).
mediaScanEnabled The setting to turn on or turn off media scan for
the virtual disk. To turn on media scan, set this
parameter to TRUE. To turn off media scan, set this
parameter to FALSE. (If media scan is disabled at
302