Dell PowerVault MD3420 - Manual (Page 17)

1
CLI Command Updates
This chapter reflects new and updated commands that are available for use with the Dell PowerVault
MD34XX/MD38XX Series storage arrays.
NOTE: Not all commands are valid with all storage arrays. Some commands are specific to certain
platforms.
CAUTION: Script commands are capable of changing the configuration and may cause loss of
data if not used correctly. Command operations are performed as soon as you run the
commands. Before using the script commands, ensure that you have backed up all data, and have
saved the current configuration so that you can reinstall it if the changes do not work.
New Commands
The following commands have been added to this guide to reflect the additional functionality available in
the PowerVault MD34xx and MD38xx series of storage arrays.
• Recover SAS Port Mis-Wire
• Reduce Disk Pool Capacity
• Register SNMP Community
• Register SNMP Trap Destination
• Set Event Alert Filtering
• Show Blocked Events
• Show SNMP Communities
• Show SNMP MIB II System Group Variables
• Show Storage Array Power Information
• Test SNMP Trap Destination
• Unregister SNMP Community
• Unregister SNMP Trap Destination
• Update SNMP Community
• Update SNMP Trap Destination
• Update SNMP MIB II System Group Variables
Updated Commands
The syntax of the following commands has been modified, updated, or enhanced since the last release of
this document.
NOTE: not all commands are valid with all storage arrays. Some commands are specific to certain
platforms.
17