Dell PowerVault MD3420 - Manual (Page 225)

Parameter
Parameter Description
diskGroup The alphanumeric identifier (including - and _) of
the disk group that you want to place in the
Security Enabled state. Enclose the disk group
identifier in square brackets ([ ]).
Additional Information
To successfully run this command, the following conditions must be met:
• All physical disks in the disk group must be self-encrypting disk (SED) physical disks.
• The Physical Disk Security premium feature must be enabled.
• The storage array security key must be set.
• The disk group must be Optimal, and not have snapshot virtual disks or repository virtual disks.
The RAID controller module firmware creates a lock that restricts access to the SED physical disks. SED
physical disks have a state called Security Capable. When you create a security key, the state is set to
Security Enabled, which restricts access to all SED physical disks that exist within the storage array.
Enable Disk Pool Security
Description
This command converts a non-secure disk pool to a secure disk pool.
Syntax
enable diskPool [diskPoolName] security
Parameter
Parameter Description
diskPool The alphanumeric identifier (including - and _) of
the disk pool that you want to place in the Security
Enabled state. Enclose the disk pool identifier in
square brackets ([ ]).
Notes
All of the physical disks that comprise the disk pool must be security capable.
225