Dell PowerVault MD3420 - Manual (Page 152)

Parameter Description
special characters, you must also put quotation
marks (" ") around the virtual disk name.
consistencyErrorFile Name of the file in which to save the consistency
error information. You must put quotation marks
(" ") around the file name.
mediaErrorFile Name of the file in which to save the media error
information. You must put quotation marks (" ")
around the file name.
priority Specifies the priority that the consistency check
has relative to host I/O activity. Valid entries are
highest, high, medium, low, or lowest.
startingLBA The starting logical block address. Use integer
values.
endingLBA The ending logical block address. Use integer
values.
verbose Captures progress details, such as percent
complete, and shows the information while virtual
disk consistency is being repaired. To capture
progress details, set this parameter to TRUE. To
prevent capturing progress details, set this
parameter to FALSE.
NOTE: The starting logical block address and the ending logical block address are useful for very
large single-virtual disk LUNs. Running a virtual disk consistency check on a very large single-virtual
disk LUN can take a long time. By defining the beginning address and ending address of the data
blocks, you can reduce the time that a virtual disk consistency check takes to complete.
Clear Physical Disk Port Statistics
Description
This command resets the statistics for all physical disk ports.
Syntax
clear allPhysicalDiskChannels stats
Parameters
None.
152