Dell PowerVault MD3420 - Manual (Page 343)

Parameters
Parameter Description
allSnmpCommunities This parameter returns information about all of the
SNMP communities in the storage array.
communityName The name of the SNMP community for which you
want to retrieve information. Enclose the SNMP
community name in double quotation marks (" ").
snmpCommunities The names of several SNMP communities for
which you want to retrieve information. Enter the
names of the SNMP communities using these
rules:
• Enclose all of the names in square brackets ([ ]).
• Enclose each of the names in double quotation
marks (" ").
• Separate each of the names with a space.
summary This parameter returns a list of the total number of
SNMP communities and the total number of SNMP
trap destinations. When you use this parameter
information detail is omitted.
Notes
SNMP supports one or more communities to which managers and managed devices belong. SNMP
requests contain a community string in the data packets passed over the network that acts as a crude
password. SNMP agents can reject GET or SET requests with an unrecognized community string. A
community string is also included in TRAP notifications sent from agent to manager as well.
The embedded SNMP agent supports both IPV4 and IPV6.
This command returns SNMP community information similar to this example.
SNMP COMMUNITIES------------------------------ SUMMARY
Total SNMP Communities: 2
Total SNMP Trap Destinations: 1
DETAILS
SNMP Community: TestComm1
SNMP Permission: Read Only
Associated Trap Destination:
Trap Receiver IP Address: 10.113.173.133
Send Authentication Failure Traps: true
SNMP Community: Test2
SNMP Permission: Read Only Associated Trap Destination:
Minimum Firmware Level
8.10
343