Dell PowerVault MD3420 - Manual (Page 370)

Parameters
Parameter Description
diskPool The alphanumberic identifier of the disk pool
(including – and _) that you want to locate.
Enclose the diskPoolName in square brackets ([ ]).
Start Enclosure Blink
Description
This command identifies an enclosure by turning on the indicator LED. (Use the stop enclosure
blink command to turn off the indicator LED for the enclosure.)
Syntax
start enclosure [enclosureID] blink
Parameters
Parameter Description
enclosure Identifies the enclosure to blink. Enclosure ID
values are 0 to 99. You must put brackets ([ ])
around the enclosure ID value.
Start iSCSI DHCP Refresh
Syntax
start raidControllerModule [(0 | 1)] iscsiHostPort [(1 | 2 | 3 | 4)] dhcpRefresh
Parameters
Parameter Description
raidControllerModule The identifier letter of the RAID controller module
that has the iSCSI host ports. Valid RAID controller
module identifier values are 0 or 1, where, 0 is the
RAID controller module in slot 0, and 1 is the RAID
controller module in slot 1.
iscsi-host-port The identifier of the port on the storage array on
which you want to refresh the DHCP parameters.
Enclose the iSCSI host port name in square
brackets ([ ]).
NOTE: This operation ends the iSCSI connections for the portal and brings down the portal
temporarily.
370