Dell PowerVault MD3420 - Manual (Page 266)

• Minimum write time (for a single write)
• Minimum synchronization data rate
• Maximum synchronization data rate
• Total write time
• Repository utilization (%)
• Recovery point age
During initial synchronization, statistics samples are captured approximately every 15 minutes.
The synchronization statistics are included in the support bundle.
Save Storage Array Configuration
Description
This command creates a script file that you can use to create the current storage array virtual disk
configuration.
Syntax
save storageArray configuration file="filename"
[(allConfig | globalSettings=(TRUE | FALSE) virtualDiskConfigAndSettings=(TRUE
| FALSE)
hostTopology=(TRUE | FALSE)
lunMappings=(TRUE | FALSE))]
Parameters
Parameter Description
file Name of the file that contains the configuration
values. You must put quotation marks (" ") around
the file name.
allConfig Saves all of the configuration values to the file. (If
you choose this parameter, all of the configuration
parameters are set to TRUE.)
globalSettings Saves the global settings to the file. To save the
global settings, set this parameter to TRUE. To
prevent saving the global settings, set this
parameter to FALSE. The default value is TRUE.
virtualDiskConfigAndSettings Saves the virtual disk configuration settings and all
of the global settings to the file. To save the virtual
disk configuration and global settings, set this
parameter to TRUE. To prevent saving the virtual
disk configuration and global settings, set this
parameter to FALSE. The default value is TRUE.
hostTopology Saves the host topology to the file. To save the
host topology, set this parameter to TRUE. To
266